Honda S2000 F20C Cylinder Head Inspection

Honda S2000



1. Remove the cylinder head.
2. Inspect the camshaft
3. Check the cylinder head for warpage. Measure along the edges, and three ways across the center.

• If warpage is less than 0.05 mm (0.002 in.) cylinder head resurfacing is not required.
• If warpage is between 0.05 mm (0.002 in.) and 0.2 mm (0.008 in.), resurface the cylinder head.
• Maximum resurface limit is 0.2 mm (0.008 in.) based on a height of 105 mm (4.13 in.).

Cylinder Head Height
Standard (New): 104.95-105.05 mm (4.132-4.136 in.)



Did you find this repair info helpful or are improvements needed? Please leave comments below.

Honda S2000 AP1

---