Additions:
{{linkunit2}}
Additions:
===''DISTRIBUTOR REMOVAL AND INSTALLATION''===
{{sourcebigbox2}}
{{sourcebigbox2}}
Deletions:
<<{{source2}}<< ===''DISTRIBUTOR REMOVAL AND INSTALLATION''===
{{source4}}
Additions:
<<{{source2}}<< ===''DISTRIBUTOR REMOVAL AND INSTALLATION''===
**Did you find this repair info helpful or are improvements needed? Please leave comments below.**
Deletions:
<<{{source2}}<< ==''DISTRIBUTOR REMOVAL AND INSTALLATION''==
Additions:
<<{{source2}}<< ==''DISTRIBUTOR REMOVAL AND INSTALLATION''==
Deletions:
>>{{sourcebigbox}}>> ==''DISTRIBUTOR REMOVAL AND INSTALLATION''==
Additions:
----
==''KA24DE IGNITION TIMING''==
1. Start engine and warm to normal operating temperature. Turn ignition off. Disconnect throttle position sensor harness connector.
2. Start engine. Increase engine speed to 2000 RPM, 2 or 3 times, then allow engine to return to idle. Engine should be operating smoothly at correct idle RPM. Check ignition timing.
{{image url="http://www.garage411.com/images/Nissan/S13/adjustments/adj1.gif" title="text" alt="text"}}
3. If ignition timing is incorrect, loosen hold-down bolt and turn distributor to adjust ignition timing. Turn ignition off and connect throttle position sensor harness connector. Recheck ignition timing.
~-Nissan 240sx S13
~- Manual Transmission: 18-22 @ 700-800
~- Automatic Transmission (in neutral): 18-22 @ 700-800
----
{{source4}}
The oldest known version of this page was created on
2009-05-06 17:39:28 by MasterBlaster
[New]