Honda S2000 Trunk

Honda S2000



Trunk Components


Trunk Circuit Diagrams

SWITCH TEST

1. Remove the rear console.
2. Disconnect the 2P connector from the switch.
3. Check for continuity between the No. 1 and No. 2 terminals.

• There should be continuity when the switch is pushed.
• There should be no continuity when the switch is released.

4. If the continuity check is not as specified, replace the switch.

SOLENOID TEST

1. Open the trunk lid.
2. Disconnect the 3P connector from the trunk latch.
3. Check solenoid operation by connecting power and ground according to the table. To prevent damage to the solenoid, apply battery voltage only momentarily.

4. If the solenoid does not operate as specified, replace it.


Did you find this repair info helpful or are improvements needed? Please leave comments below.


Honda S2000 AP1

---